5299 potting adhesive for LED lamp and power supply
● Product Features:
Double component, addition type.
Room temperature or heating curing.
High performance on insulation, damp proofing, vibration resistance, chemical resistance, electricleakage resistance.
No need to add primer coating before use
High & low temperature resistant
(UL94-1996) V0
| Item |
Unit |
Typical Value |
| Color |
Component A |
|
Grey |
| Component B |
|
White |
| Component of Basic Materials |
|
Polysiloxane |
| Density |
Component A |
g/cm3 |
1.57 |
| Component B |
1.57 |
| Viscosity |
Component A |
mPa*s |
3600 |
| Component B |
3800 |
| After Mixed |
3800 |
| Mix Ratio by weight (A:B) |
|
1:1 |
| Handing Curing Time |
min |
85 |
| Initial Curing Time |
hour |
6 |
| Full Curing Time |
min(80℃) |
25 |
| Thermal conductivity |
After Curing |
W/(m·K) |
0.63 |
| Dielectric constant |
1.2MHz |
3.0 |
| Harness |
Shore A |
65 |
| Volume Resistivity |
Ω*cm |
1.5x1014 |
| Dielectric Strength |
KV/mm |
21 |
| Work Temperature |
℃ |
-60~2 |
● Main Applications:
For the deep potting of power supply and electronic components and parts.
Especially suitable for the potting of inside and outside LED displays that request for flame retardant.
● How to Use
Before use, stir component A by hand or machine properly, keep component B sealed in the can and cut a proper hole at the sharp mouth of cartridge.
Check whether it’s adhering to Applied Materials theoretically.
Mix component A and B with the mix ratio A:B=1:1 by weight. Before hand simple tests are requested if you need to change the mix ratio.
Natural defoaming or vacuum defoaming. Natural defoaming: mix component A and B, stewing 20-30 minutes. Vacuum defoaming: The vacuum degree 0.08-0.1Mpa.Vacuum pumping 5-10 minutes.
Perfusion: Completed in Handing Curing time
Curing: Ø Room temperature or heating curing. In winter, curing time is longer, so suggest heating to curing.
3. PHYCIAL AND CHEMICAL PROPERTIES
Smell No obvious odor
Appearance Grey liquid
Ignition Point >200℃
Melting Point No data
Boiling Point >200℃
Flash Point >200℃
Watersolubility Insoluble
PH 7
Relative Density(water=1) >1.0g/cm3 (20℃)
Vapour pressure Less than 5mm mercury
Upper Explosive Limit %(v/v) No
Lower Explosive Limit %(v/v) No
4.Huitian Introduction
Huitian is a professional and the largest adhesive manufacturer in China based on advanced technique and production. Our product range covers new energy, automotive and engineering vehicle, electronics and electric appliances, military and high-tech industry.
Product Tags:
|
|
5299 Silicone Potting Compound for LED lamp , circuit board potting compound Images
|
